Technical note: using Distributed Temperature Sensing for Bowen ratio evaporation measurements

Technical note: using Distributed Temperature Sensing for Bowen ratio evaporation measurements

Schilperoort, B. (TU Delft Water Resources)
Coenders-Gerrits, Miriam (TU Delft Water Resources)
Luxemburg, W.M.J. (TU Delft Water Resources)
JIMENEZ RODRIGUEZ, C.D. (TU Delft Water Resources; Escuela de Ingeniería Forestal)
Cisneros Vaca2, C. (University of Twente)
Savenije, Hubert (TU Delft Water Resources)

2017

Rapid improvements in the precision and spatial resolution of Distributed Temperature Sensing (DTS) technology now allows its use in hydrological and atmospheric sciences. Introduced by Euser [Hydrol. Earth Syst. Sci., 18, 2021–2032 (2014)] is the use of DTS for measuring the Bowen ratio (BR-DTS), to estimate the sensible and latent heat flux. The Bowen ratio is derived from DTS measured vertical profiles of the air temperature and wet-bulb temperature. However, in previous research the measured temperatures were not validated, and the cables were not shielded from solar radiation. Additionally, the BR-DTS method has not been tested above a forest before, where temperature gradients are small and energy storage in the air column becomes important.

In this paper the accuracy of the wet-bulb and air temperature measurements of the DTS are verified, and the resulting Bowen ratio and heat fluxes are compared to eddy covariance data. The performance of BR-DTS was tested on a 46 m high tower in a mixed forest in the centre of the Netherlands in August 2016. The average tree height is 26 to 30 m, and the temperatures are measured below, in, and above the canopy. Using the vertical temperature profiles the storage of latent and sensible heat in the air column was calculated.

We found a significant effect of solar radiation on the temperature measurements, leading to a deviation of up to 3 K. By installing screens, the error caused by sunlight is reduced to under 1 K. Wind speed seems to have a minimal effect on the measured wet-bulb temperature, both below and above the canopy. After a simple quality control, the Bowen ratio measured by DTS correlates well with eddy covariance (EC) estimates (r2 = 0.59). The average energy balance closure between BR-DTS and EC is good, with a mean underestimation of 3.4 W m−2 by the BR-DTS method. However, during daytime the BR-DTS method overestimates the available energy, and during night-time the BR-DTS method estimates the available energy to be more negative. This difference could be related to the biomass heat storage, which is neglected in this study.

The BR-DTS method overestimates the latent heat flux on average by 18.7 W m−2, with RMSE = 90 W m−2. The sensible heat flux is underestimated on average by 10.6 W m−2, with RMSE = 76 W m−2. Estimates of the BR-DTS can be improved once the uncertainties in the energy balance are reduced. However, applying e.g. Monin-Obukhov similarity theory could provide independent estimates for the sensible heat flux. This would make the determination of the highly uncertain and difficult to determine net available energy redundant.

http://resolver.tudelft.nl/uuid:02480179-8093-441b-ae28-74859c12463c

https://doi.org/10.5194/hess-2017-446

1812-2116

Hydrology and Earth System Sciences Discussions

Institutional Repository

journal article

© 2017 B. Schilperoort, Miriam Coenders-Gerrits, W.M.J. Luxemburg, C.D. JIMENEZ RODRIGUEZ, C. Cisneros Vaca2, Hubert Savenije