Energy harvesting on the human body

Energy harvesting on the human body: Hybrid charge pump design for cold start compatibility and high efficiency harvesting with minimal footprint

van Wietmarschen, Luc (TU Delft Electrical Engineering, Mathematics and Computer Science; TU Delft Bio-Electronics; Nowi-Energy B.V.)

Serdijn, Wouter (mentor)
Babaie, Masoud (graduation committee)
Rodrigues Mansano, Andre (graduation committee)

Delft University of Technology

2019-06-28

This work proposes a new charge pump design suitable for energy harvesting on small human wearable devices. By using only one system for both cold start and high efficiency harvesting, the required silicon area is heavily reduced. The most fitting energy transducer is determined to be a photovoltaic cell, based on aspects of voltage, power and size. Both indoor and outdoor lighting conditions are suitable. The literature on fully integrated voltage boosting with special attention to cold start shows that the capacitive charge pump is the best solution for high efficiency, low power and small size voltage boosting. For cold start applications, a Dickson charge pump with dynamic charge transfer switches is the best solution. For achieving high efficiency conversion, theMakowski charge pump is the best.
The proposed design combines the advantages of the Dickson charge pump for cold start and the high efficiency aspects of aMakowski charge pump for normal operation in one system with minimal silicon area. Using capacitor splitting, the conversion ratio of the cold start charge pump can be orthogonally chosen from
the conversion ratio of normal operation. Dynamic charge transfer switches are used for the cold start charge pump to increase the performance. An implementation of the proposed design is made in Cadence Virtuoso and is tested for cold start capability and efficiency across five process corners and three temperatures. The results prove that the proposed design can achieve high efficiency energy harvesting that is on average 5% below the efficiency of a normal Makowski charge pump. Cold start was achieved from 100mV that is boosted to a battery voltage of 1.8 V within the micro-watt power range. With these results, the proposed charge pump is suitable for photovoltaic energy harvesting in small devices. The required silicon area is reduced by 50%, compared to systems where cold start and high efficiency harvesting are provided by separate systems.
The proposed design is made into a lay-out, which is currently being tested and will be manufactured in the coming months.

charge pump
Energy Harvesting
integrated circuits
analog circuit design
Photovoltaic
Makowski charge pump
Dickson charge pump
Low power
low voltage
Cold start

http://resolver.tudelft.nl/uuid:03532d19-2f51-47d8-ad5c-46cd553e2b2d

2020-07-01

Student theses

master thesis

© 2019 Luc van Wietmarschen