Speed limits and their effect on freeway capacity

Speed limits and their effect on freeway capacity: An investigation of two lane freeway bottlenecks

van Lindonk, William (TU Delft Civil Engineering and Geosciences)

Hoogendoorn, S.P. (mentor)
Knoop, V.L. (graduation committee)
van Cranenburgh, S. (graduation committee)
Taale, Henk (graduation committee)

Delft University of Technology

2020-09-10

In this thesis an investigation is performed into the effect of different speed limits on freeway capacity. From literature, much is known about the variety of factors that affect capacity, but the exact effect of the speed limit on capacity is not yet clear. In recent years, several speed limits changes have taken place at multiple two-lane freeway bottlenecks throughout The Netherlands, which makes it possible to compare effects of different speed limits at the same location. To evaluate the effect of the speed limit on capacity, the Product Limit Method has been applied to identify breakdown flows and generate capacity distributions, which could subsequently be compared for different limits. In the comparison of capacity distributions under different speed limits, it was found that significant changes in capacity had occurred, but that no uniform direction of the effect could be found. Subsequently, to control for location specific factors and other variables, Fixed Effects regression has been used to determine the effect of the speed limit on the breakdown flow. It was found that the breakdown flow under the 120 km/h limit was significantly higher than under the 130 km/h limit (in the range of 60 to 190 vehicles per hour) and that the breakdown flow under the 100 km/h limit was, in some cases, also higher than under the 130 km/h limit. In addition to this, it was found that a significant positive relation exists between the height of the speed limit and the fraction of flow in the passing lane. Moreover, it was shown that the relation between the fraction of flow in the passing lane and the level of breakdown flow was best represented by a quadratic relation, which could indicate that an “optimal” distribution of flows may exist. Given the results of this thesis, it is posed that a change in the speed limit is likely to affect capacity primarily through altering the lane flow distribution and that it will depend on the layout of a freeway location what the optimal lane flow distribution is and which speed limit leads to this optimal lane flow distribution.

Speed Limits
Capacity Research
Breakdown Flow
Product Limit Method
Fixed Effects Regression
Two-Lane Freeway
Traffic Flow Theory
Lane Flow Distribution
Bottleneck Identification
Capacity Distribution

http://resolver.tudelft.nl/uuid:1181cb6e-ff70-4f12-bea6-ab513865d4e8

Student theses

master thesis

© 2020 William van Lindonk