A feasibility study into the application of low-fidelity models for the prediction of the shell modes of a wind turbine tower with a slip joint

A feasibility study into the application of low-fidelity models for the prediction of the shell modes of a wind turbine tower with a slip joint

Seegers, Jeroen (TU Delft Mechanical, Maritime and Materials Engineering)

Cabboi, A. (mentor)
Cicirello, A. (graduation committee)
Sánchez Gómez, S. (graduation committee)
Colomés, Oriol (graduation committee)

Delft University of Technology

Offshore and Dredging Engineering

2022-07-22

The slip joint connection is a relatively new alternative method for connecting offshore wind turbine towers to prior installed monopiles. It consists of two overlapping conical sections that together form a connection. There are several challenges left to be solved before the slip joint can be applied on a commercial scale. One of those challenges lies in the decommissioning process of the slip joint connection. It is proven that build-up settlement can increase the friction force within the joint over its lifetime and complicate its disconnection. One potential method for reducing the friction force in the slip joint is the excitation of one of the structures shell modes localized around the slip joint. Good estimations of the shell modes of the structure are therefore essential. Models for precise estimation of the shell modes of a wind turbine with a slip joint are difficult and expensive to develop due to the complexity of the joint. This thesis is a study into the possibility of using simplified finite element models to estimate the shell modes of a wind turbine connected with a slip joint. This is done by estimating the shell modes of the structure using a reference model and seven simplified models in a modal analysis. The estimated shell modes are compared based on their eigenfrequency and mode shape. Based on this comparison, conclusions about the applicability of simplified models are drawn. The first 300 eigenmodes of the structure are estimated with both the reference model and simplified models. Of these eigenmodes, ten shell modes of interest are selected based on their eigenfrequency and location at which the modes are localized. The modes of interest are than compared for their eigenfrequency and mode shape. The mode shapes are compared based on the Modal Assurance Criterion (MAC), which is calculated at a specific location of interest. In addition to this, the angle in which the modes are orientated is measured and compared, as this can be useful information for the decommissioning process. Results showed that three out of seven simplified models studied resulted in a estimation of the shell modes which was sufficiently accurate. The simplifications used for these models consist of the averaging of wall thickness for the upper and lower slip joint and a simple model for the upper slip joint. From these results it can be concluded that some of the simplifications can be applied when estimating shell modes of a wind turbine tower connected with a slip joint, as they lead to only a small decrease in accuracy of the shell mode estimation. However, using these results to make predictions about other potential simplifications is challenging as each different simplification has a unique influence on the estimation of the shell modes.

Slip Joint
Eigenmode analysis
Wind Turbine
Vibration
Decommissioning

http://resolver.tudelft.nl/uuid:5a3f9c2e-b273-41e1-8469-deaea2810957

Student theses

master thesis

© 2022 Jeroen Seegers