Analysing the Performance of SPLITTER

Analysing the Performance of SPLITTER: A Noise Removal Algorithm for DESHIMA 2.0

Ligthart, Liam (TU Delft Applied Sciences)

Endo, A. (mentor)
Rybak, M. (graduation committee)

Delft University of Technology

Applied Physics

2022-07-06

More insight has been gathered on the performance of the SPLITTER (Stationary spectrum Plus Low-rank Iterative TransmiTtance EstimatoR) algorithm as developed by Brackenhoff for denoising data gathered from observations of high-redshift galaxies. By using matrix decomposition to split the gathered data into a low-rank atmosphere matrix and a sparse matrix with the signal and photon noise, the algorithm avoids the subtraction of two noisy signals, and therefore the factor of √2 additional noise that comes with it. The algorithm was specifically developed for DESHIMA 2.0 (DEep Spectroscopic HIgh-redshift MApper), a wideband spectrometer that achieves a bandwidth from 220 to 440 GHz, using 347 spectral channels. Previous performance tests of the algorithm included the comparison of the weighted root mean square error between SPLITTER and the usual technique of Direct Subtraction on realistic data simulated using the TiEMPO (Time-dependent End-to-end Model for Post-process Optimization) software package. This resulted in a ~1.7 improvement factor for the whole spectrum and ~1.3 in the emission line area.

The performance of SPLITTER on two key components of the spectrum have been analyzed separately. First, the measurement of the continuum has been analyzed by using TiEMPO to create realistic simulations of the observation of custom spectra with a linear continuum. SPLITTER showed to be more precise as the noise level was lower, but less accurate, as there was a systematic offset in the estimated continuum. Using a modified black body model for the continuum and assuming the relative offset is independent of the strength of the continuum, the observed offsets and errors were propagated to offsets in estimations of dust temperature $T_{dust}$ and spectral emissivity of the dust $\beta$. Because of the offset, SPLITTER also showed a systematic offset in estimated $T_{dust}$, but as the algorithm is more precise, it performed better at estimating $\beta$, since $\beta$ determines the shape of the spectrum and has less influence on the strength. Second, to test the detection of emission lines, custom spectra have been created containing the same linear continuum and single spectral line at four different frequencies. Each line was set to have a known signal to noise ratio compared to the photon noise in its frequency bin. The retrieved signal to noise ratio as compared to noise of neighboring bins showed an improvement of ~1.9 for SPLITTER compared to Direct Subtraction for bright lines. Weak lines did not show any improvement in SNR. There seemed to be no correlation between continuum overestimation and emission line measurements.

Conclusion is that SPLITTER definitely shows improvement in noise reduction, but comes with an overestimation of the continuum. The consequences of this are that Direct Subtraction is still preferred for estimating dust temperature, but for estimations of spectral emissivity and detection of emission lines, SPLITTER is more robust.

DESHIMA
SPLITTER
astronomy
terahertz
dusty galaxies
denoising
spectrometer
Submillimeter-wave
submillimeter galaxies
high redshift

http://resolver.tudelft.nl/uuid:5f94f473-4171-43f2-9171-02849a57f010

Student theses

bachelor thesis

© 2022 Liam Ligthart