Turbulent Viscous Drag Reduction in Air by Compliant Surfaces

Turbulent Viscous Drag Reduction in Air by Compliant Surfaces

Lai, Yu-Jui (TU Delft Aerospace Engineering)

van Oudheusden, B.W. (mentor)
Schrijer, F.F.J. (mentor)
van Nesselrooij, M. (mentor)
Delfos, R. (graduation committee)
Baars, W.J. (graduation committee)

Delft University of Technology

Aerospace Engineering

2021-02-26

This research studies the fluid-structure interaction (FSI) of compliant surfaces in air flows, with an objective of finding possible turbulent viscous drag reduction. A compliant surface is a thin layer of viscoelastic material drawing inspiration from dolphin epidermis, which was thought to have drag-reducing capabilities by Gray (1936). Research into the drag reduction capabilities of compliant surfaces has been long going for more than five decades, starting with Kramer (1960), yet no firm conclusion has been reached. In addition, most of the experimental research has been focused on water flows, with air flows regarded as incapable of inertially forcing a compliant surface to deform. This research attempts to disprove this assumption by applying the proper inertial scaling to the FSI between the compliant surface and air flows. Compliant surfaces are characterised by the stiffness and thickness, which are presumed to be of first-order influence on the FSI. A parameter sweep of these compliant surface properties was conducted by drag delta measurements and flow visualisation by planar particle image velocimetry (PIV) in the M-Tunnel at the Low Speed Laboratory (LSL) Drag delta results confirm the possibility of turbulent viscous drag reduction by compliant surfaces, with a measured drag delta of -3.43 %. This result is further supported by the decrease in 1D turbulence intensity at the test plate's trailing edge from hot-wire measurements, and a smaller decay of the shape factor H from PIV. Quadrant analysis of the PIV data found evidence of a reduction in combined Q2 and Q4 events, further supporting the drag delta measured. Correlation between the compliant surface's viscoelastic properties and the drag delta found a negative correlation between the magnitude of complex shear modulus and a positive correlation between the loss tangent and drag reduction. The high loss tangent for the drag-reducing compliant surface and its subtle positive correlation with the drag reduction indicates that the viscoelasticity might have a greater influence on the FSI than expected.

Drag reduction
Turbulent boundary layer
Passive flow control
Compliant surface
Fluid-structure interaction
Quadrant analysis

http://resolver.tudelft.nl/uuid:a470acae-1238-4e47-a986-11fc69378f6b

2023-02-26

Student theses

master thesis

© 2021 Yu-Jui Lai