Deciding where to verify the fatigue resistance of an orthotropic steel bridge deck

Deciding where to verify the fatigue resistance of an orthotropic steel bridge deck

Stellinga, Coen (TU Delft Civil Engineering & Geosciences)

Cicirello, A. (mentor)
Veljkovic, M. (graduation committee)
Steenbergen, M.J.M.M. (graduation committee)
Dorgelo, G. (graduation committee)

Delft University of Technology

Civil Engineering

2023-04-24

To reduce the environmental impact or cost of a civil engineering structure their designs are optimized. A promising method to optimize are iterative optimization algorithms. If both the design calculations and the iterative optimization algorithm are automated, an optimized design solution can be found within a feasible timeframe. To be able to automate the design calculations they need to be fully parameterizable. In this context it becomes interesting to research whether yet unparameterizable calculation processes can be made parameterizable. One of these processes is the determination of the locations in which the fatigue resistance has to be determined in a steel orthotropic bridge deck. This location is the location where the first fatigue crack is expected. Therefore, Antea Group requested if a study could be performed with the objective to answer the following research question:
How can the determination of the location of the first fatigue crack in the deck, at a stiffener to deck plate weld toe, be parameterized?
To answer the research question, the (in the Netherlands active) regulations are studied. Based on the regulations the process of determining fatigue damage of a point in the bridge can be understood. As well as the reason why, this process is too computational demanding and complex to be able to be applied to all points in all welds.
In response to this an alternative method is proposed. This method reduces the complexity and the computational budget that is needed, by using 1D elements instead of the currently prescribed 2D elements. To determine if this method can be used it was decided to apply it on a case study. The bridge which served as the case study was the Goereese bridge. The alternative method was applied to determine the expected distribution of fatigue damages in all welds in the case study. Based on this obtained distribution a limited number of interesting locations in the deck could be identified. At these points to regulatory required method was used to obtain results which can be compared with the alternative method.
It is concluded that the predicted location of the first fatigue crack of both methods is directly next to each other. However, the distribution of the remaining points suggest by the alternative method does not agree with the obtained results of the regulatory method. Remarkable enough, both these methods predict a location which is counter intuitive to the structural engineers participating in the research.
Therefore, the following general recommendations are given:- Research if the regulatory method, to determine the location of the first fatigue crack, can be simplified. - Research the cause(s) of the differences between the regulatory method and the alternative method. - Increase the awareness of structural engineers regarding their intuition on the location of the first fatigue crack.

Orthotropic Steel Deck
Fatigue crack location
FEM

http://resolver.tudelft.nl/uuid:10ea37a0-e155-40da-aae0-9e88d4dc55ad

Student theses

master thesis

© 2023 Coen Stellinga