Deformation and Aerodynamic Performance of a Ram-Air Wing

Deformation and Aerodynamic Performance of a Ram-Air Wing

de Wachter, A.

Ockels, W.J. (mentor)
Boermans, L.M.M. (mentor)
Breukels, J. (mentor)
Ruiterkamp, R. (mentor)

Aerospace Engineering

2008-09-30

Ram-air wings form an ever increasing market of soft fabric, air inflated wings. They are primairily used in air sports such as parachuting, paragliding and kiting. Ram-air kites may also be used for electric power generation by letting the kite pull a cable from a drum that is connected to a generator. An example if this principle is the Laddermill concept. But since ram-air wings are flexible by nature they will deform and depart from their intended design shape when they are loaded by aerodynamic forces. These deformations generally affect the performance of the wings adversely. Kites with a higher lift-to-drag ratio on the Laddermill could mean a direct increase of the energy produced per square meter of kite. Besides this benefit for the Laddermill there is a huge, world-wide market of parachuting, paragliding and kiting that can benefit from more research and a better understanding of the deformation and aerodynamic performance of ram-air wings. The goals of this thesis are to be able to point out where a ram-air kite departs from the intended design shape, to investigate how well the kite performs, to understand how the deformations affect the airflow and to make suggestions for possible improvements of the design. Since little has been published about these subjects this report will most of all form a basis for further research. This report presents a method to analyse the shape and the aerodynamics of a ram-air kite. The kite is tested in the windtunnel. Its 3D shape is captured using two techniques: photogrammetry and laser scanning. Using the geometry data the structural deformation of the wing is dissected. With computational fluid dynamics the aerodynamics of the deformed shape is analyzed. An extra result of this study is the comparison of photogrammetry and laser scanning in terms of their suitability to capture the 3D shape of the ram-air kite. A number of interesting deformations and flow features were found on the ram-air wing: - Theoretically the bumps (ballooning) and grooves on a ram-air wing hinder the spanwise flow on a 3-dimensional wing, but in practise this effect is only visible on small parts of the upper surface. - The pull of the suspension lines on the under surface and the internal construction of the wing make the upper surface of the wing deform. This results in a decrease of the upper surface curvature, especially near the nose. This curvature decrease causes a loss of lift of at least 5%. - Because the flat, 2-dimensional fabric is inflated into a 3-dimensional shape the fabric wrinkles. The wrinkles continue from the top and bottom surface into the ribs that internally connect and support the top and bottom surface. On average these wrinkles shorten the ribs in chordwise direction by 3.5%. This decreases the surface area of the wing and it makes the ribs effectively thicker. Many more details became visible with the thorough analysis of the wing’s shape. The conclusion is that the performance of the ram-air wing can be improved by changing these details. The photogrammetry measuring technique gave better results than laser scanning and is very suitable tool to make these details visible. It allows a designer to identify where the real flying shape deviates from the design shape. This can help kite designers and designers of other ram-air wings to reverse-

ram air wing
performance
deformation

http://resolver.tudelft.nl/uuid:786e3395-4590-4755-829f-51283a8df3d2

Student theses

master thesis

(c) 2008 Aart de Wachter